Register
Log In
October 15, 2009
Offline
Hi gang,
I haven't posted in a couple years..... Been otherwise occupied.
I'm wondering how I can adjust the "trigger stop" screw on my model 40 Supermag. I really don't wanna take it down
too far,.......'cause it's Beautiful!! But I think I'll shoot better with less overtravel.Â
I've even thought of cutting a slot in it from the inside of trigger guard.
Any thoughts?
                        HankÂ
Supporter
Moderators
January 24, 2009
Offline
You could maybe turn it with needle nose pliers. A thin rubber hose on each jaw of the pliers will help against gouging the screw. I haven't adjusted that screw on my guns, so I'm not sure how tight it is.
Supporter
Moderators
Dans Club
February 22, 2009
Offline
Once you strip it down, just put the screw in backwards. Then you can adjust at the shooting bench, using an allen wrench...
Technically, the glass is always full; half liquid, half air....
1 Guest(s)
