Log In
Supporter
Moderators
Dans Club
February 22, 2009
Offline
Does anyone index their barrels & shrouds?
ÂÂ
I ask because I have a 10" barrel w/ a scope for the 41 and am thinking about using it on a frame that normally carries a 6" set up. Switching back and forth is a concern because I believe the point of impact would change each time I switch out. I'm guessing that if I indexed the assemblies, the shift in POI would be reduced.
ÂÂ
Thoughts?
Technically, the glass is always full; half liquid, half air....
Dans Club
March 2, 2008
Offline
Ron- For what it's worth, I have a scope mounted on an 8" shroud for my 715 that does not seem to show a lot of variance in POI when I uninstall/reinstall it. The scope is on a Burris mount, and leave it installed on the shroud. I am pretty careful to install the shroud and gap the barrel as consistently as possible, and I don't find it to be a problem.
I went to a bookstore and asked the saleswoman "Were is the Self Help Section?" She said if she told me, it would defeat the purpose.
George Carlin
February 2, 2009
Offline
I've got a set of barrels for my model 40, from 6" to 10" and two 8"; one scoped and one open. I have taken the entire set to the range and changed them out with no detectable difference in POI at 25 and 50 yds with the various barrels, as long as I g
ap them consistently.
Supporter
Moderators
Dans Club
February 22, 2009
Offline
Alrighty then; guess I'll go sight in the scope and try it.
ÂÂ
Thanks for the input
Technically, the glass is always full; half liquid, half air....
1 Guest(s)
