Register
Log In
October 19, 2019
Offline
Is this a timing issue? Something I can fix or is it gunsmith time?
The cylinder misalignment can be seen on the left side as thin black crescent.
It's the same at all indexes. Brand new factory 4" barrel - I have not checked this with the original 6".
Supporter
Moderators
Dans Club
February 22, 2009
Offline
We, or at least I, can't see your picture.... Check here for "how to"
Technically, the glass is always full; half liquid, half air....
DWF Supporters
July 12, 2020
Offline
I can't see it either.
October 18, 2017
Offline
With no photos to go on we can only speculate. Assuming youâre talking about looking down the barrel with a bright light; yes, it would seem that the cylinder rotation is coming up a little short. When you say âindexesâ are you certain the cylinder is locked in place by the bolt, or do you have to turn the cylinder by hand to complete the lockup, and if this rotation is then complete, is proper alignment achieved? If this is the case, replacing the hand should remedy the problem. However, a very badly bent crane could also cause the mis-alignment youâre speaking of with the bolt locked in bolt cuts. If a few very clear photos could be submitted it would greatly assist with a correct diagnosis.
1 Guest(s)
