Log In
August 27, 2010
Offline
Hi All,
Â
Just recently got a SS 357 Max with a slotted 8" barrel then picked up a 10" HV barrel. Went to change it and I see that the roll pin is broke off in the frame and a hand made locator pin was placed in the barrel and cut down to fit into the roll pin fragment remaining in the frame. No issue getting it all apart but I thought I'd just ask here to see if anyone knows what size the pin is.
Â
Thanks
February 16, 2016
Offline
I've seen that somewhere on here before, so someone should chime in with the size shortly.
Three posts in 13-years is some kind of willpower, I've never seen before.
Supporter
Moderators
Dans Club
February 22, 2009
Offline
Shroud locator pin is a 3/32" roll pin (.100") as measured on one of my 740s.
Technically, the glass is always full; half liquid, half air....
DWF Supporters
July 12, 2020
Offline
I don't think there was ever an asked question about these revo's that has not been answered by the members here!!!!!
August 8, 2016
Offline
Dans Club
December 7, 2020
Offline
Since my 445 has that issue, here's a followup:
"How long should the roll pin be?" Â
I am just going to make one out of stainless bicycle wheel spoke
DWF Supporters
July 12, 2020
Offline
Here ya' go Scout!
https://www.mcmaster.com/products/roll-pins/
The anti vibration coiled one seems to be a good choice as it also helps if the hole gets a little out of round from use or drilling the old one out.
Supporter
Range Officer
Moderators
DWF Supporters
Dans Club
December 4, 2011
Offline
Harbor Freight sells roll pin assortments in a big case for reasonable prices. I keep one on my bench for odd jobs. Same with o rings and sealing washers. Â
Anything worth doing is worth doing well.
My father
If a man designed it, and a man built it, then a man can fix it.
My grandfather
1 Guest(s)
