Register
Log In
December 27, 2010
Offline
How can you take off cylinder to rechamber without taking gun apart?
September 26, 2010
Offline
I guess it depends on what you consider taking the gun apart. If you are referring to Dan Wessons I would say the answer in no.
Range Officer
Range Officers
Dans Club
March 27, 2009
Offline
The Dr is correct, unless it is a porkchop Dan.
Supporter
Moderators
January 24, 2009
Offline
If it's a DW, you will at least need to remove the side plate to get the cylinder off. With a Porkchop, you can remove the shroud, then the crane/cylinder slips right out.
August 28, 2009
Offline
Walt - you need to get in there and start tearing some guns apart. Once you do a couple you can do them blindfolded - they're the simplest firearms on the planet to tear down.
December 27, 2010
Offline
well it took all of 5 minutes to take out cylinder thanks to shoots instructions.I have a couple questions does ejector rod unscrew from cylinder? C clip has a flat side on it which way does it go it fell out when I playing aroung trying to find it.Good news is very clean inside only one small rub mark.Ihave wolf sping kit so I might as well put it inI will rent reamernext week and start to rechamber.thanks walt
1 Guest(s)
