Register
Log In
Home
Slugging barrel for cast boolits
Wbrco
Member
Members
Forum Posts: 31
Member Since:
February 3, 2018
February 3, 2018
Offline1
May 5, 2018 - 5:18 pm
On the gun with the shroud on, or off and just the barrel?. Any comments on how consistent the barrels and cylinder throats are?
rwsem
SOWELA (Southwest Louisiana)
Supporter
Members
Moderators
Dans Club
Moderators
Dans Club
Forum Posts: 5429
Member Since:
February 22, 2009
February 22, 2009
Offline2
May 6, 2018 - 7:09 am
The revolver dimensions should be largest at the cylinder throat and smallest in the bore. Either slug the cylinder throat or invest in a minus pin gauge set. I disassemble and slug the barrels but that's personal preference. When I size the cast boolet, I usually run .001-.002 over the cylinder throat size.
If you have a bore dimension greater than the cylinder throat (not including the forcing cone), you'll have leading issues and affects on accuracy. Easy to correct- have the throat reamed.
Technically, the glass is always full; half liquid, half air....
Forum Timezone: America/New_York
Most Users Ever Online: 658
Currently Online:
Guest(s) 202
Currently Browsing this Page:
1 Guest(s)
1 Guest(s)
Top Posters:
Steve: 10330
SHOOTIST357: 4788
Dave_Ks: 4300
Ole Dog: 4230
Stinger: 3636
Supermagfan: 3291
zoommb: 3161
IHMSA80x80: 3014
Blacktop: 3004
brucertx: 2311
Newest Members:
Alfin947
Haljax3095
abinymn
Anya123sn
Danlor697
Dizaynersk_apEt
Aljax037
AndreBot
Owenjet
Edmax8920
Forum Stats:
Groups: 11
Forums: 42
Topics: 17072
Posts: 151217
Member Stats:
Guest Posters: 87
Members: 12261
Moderators: 4
Admins: 1
Administrators: Jody
Moderators: lbruce, Charger Fan, rwsem, SCORPIO
© Simple:Press —