Register
Log In
Supporter
Range Officer
Range Officers
May 2, 2009
Offline
So I wanted to pull some 14-2 front sights so I could refinish a few shrouds. Some of my shrouds have pins that go completely through--no problem 🙂
I have two 4" shrouds that only have the pin visible on one side. I figured a few good whacks with the drift punch and it would pop through the other side...wrong !
after about the 3rd whack, my drift had a nice bend in it -- subsequent attempt to straighten drift resulted in broken drift....
So do I need to drill the pin from the blind side?
SHOOT
Dans Club
March 2, 2008
Offline
Drill it, install a new pin. Who Knew?
Blind roll pins suck
I went to a bookstore and asked the saleswoman "Were is the Self Help Section?" She said if she told me, it would defeat the purpose.
George Carlin
Supporter
Moderators
January 24, 2009
Offline
Steve CT said:
Blind roll pins suck
That's for sure. I've got a blind roll pin holding the firing pin on my Seville's...which means that if you want to take it apart & clean in there, it ain't happenin' capn'.
1 Guest(s)
