Register
Log In
March 20, 2022
Offline
Thanks for the add, Happy to be part of the forum. I just picked up an 8â 22 and it shots great , really impressed with the double action for a 22. Iâve put a couple hundred rounds through it and have excessive fouling around the cylinder, the cylinder gap seems a little wide, about .008 or so. I ordered a barell nut wrench and plan to make it smaller. I have a single six and a high standard with much tighter cylinder gap. The Dan Wessons are beautiful guns and am excited to get it dialed in.
Supporter
DWF Supporters
June 11, 2016
Offline
Welcome to the Forum from Wisconsin. The gap should be no more than .06 and can even be a little less depending on the tightest point on the cylinder.
Dans Club
December 5, 2008
Offline
Welcome to the Forum!
DWF Supporters
July 12, 2020
Offline
Welcome to the forum from PA!
Dans Club
February 24, 2013
Offline
Welcome from central IL!! As already mentioned, be sure to gap at each cylinder to make sure tightest spot is at the gap of your choiceâ¦typically .006â for most Dans, .002â for SuperMags. Â
February 16, 2016
Offline
to the 
March 20, 2022
Offline
Thank you guys. An update, I got the barell nut off and adjusted the gap to .006 and was much better, then decided to go to .004 and was going to shoot but got busy doing other stuff
