Register
Log In
January 2, 2012
Offline
will a 357 wrench fit a 22 barrel assembly Thanks Randy
Range Officer
Range Officers
Dans Club
February 28, 2009
Offline
No, because while the shroud and barrel nut are the same size, the .357 pilot won't fit the .22 bore.
I suggest getting a proper barrel nut wrench from EWK arms, they are top quality. See his add in the right hand column.
BTW, welcome to the DWF.
-Mike
January 2, 2012
Offline
I only have the 357 now. I am looking for a 22. It seems like most of them dont have the wrench with them Randy
January 22, 2008
Offline
If you buy a wrench from Eric they will work for the difference calibers because the pilot will switch out. Â As Mike pointed out the factory wrenches can only be used for their specific caliber.
Range Officer
Range Officers
Dans Club
March 27, 2009
Offline
EWK is the only Wrench to buy! Â While you are at it buy a new nut. Â When removing make sure not to strip old nut as this is another problem. Â
January 2, 2012
Offline
any help finding a 22 in northeast nc or southeast va would be appreciated It seems like gun broker is high and the same guns keep getting relisted over and over with reserves that are not met thanks Randy
Supporter
Moderators
January 24, 2009
Offline
The 22's tend to fetch a higher price overall, than the 357's. It seems there were fewer of them made, so the price reflects the demand.
However, not & then a good deal can be found, so don't give up.
December 26, 2010
Offline
Welcome to the forum. Â As others have said, Eric's wrench is top quality and the pilots are interchangeable. Â
Â
Good luck on your search for a 22.  Their is this one on Armslist.com http://www.armslist.com/posts/267022/columbus-ohio-handguns-for-sale--dan-wesson-22
1 Guest(s)
