Two toned .22 original or bubba'd? Revolvers Forum Dan Wesson Forum

Please consider registering
Guest

Home Forum Revolvers Two toned .22 original or bubba'd?

Two toned .22 original or bubba'd?

Hsimmons

Member

Members

Forum Posts: 2

Member Since:
March 3, 2013

Offline

December 18, 2014 - 10:41 pm

Does anyone know if Dan Wesson ever made two toned revolvers?  I purchased this 17XXX .22 used with no box or papers about 30-years ago. It had the satin hard chrome finish shown here on the cylinder, latch and ejector rod.  The 8-inch barrel shroud was also chromed, but the finish is much rougher than on the other components. It seems like a professionally applied finish but I've always assumed it was done after the fact.  It has held up to 30-years of use with no wear marks at all.  I've been thinking about sending it to Norwich for new blued components but don't want to do that if by chance the gun was made this way. Any ideas?

SCORPIO

Supporter

Range Officer

Members

Moderators

DWF Supporters

Dans Club

Forum Posts: 4268

Member Since:
December 4, 2011

Offline

December 18, 2014 - 10:45 pm

I don't think the factory offered two tone revolvers, it was most likely done aftermarket by an owner.

Anything worth doing is worth doing well.

My father

If a man designed it, and a man built it, then a man can fix it.

My grandfather

Ole Dog

ocala, fl

Supporter

Members

Dans Club

Forum Posts: 4348

Member Since:
March 25, 2013

Offline

December 19, 2014 - 1:17 am

You can find a Monson shroud of you choosing on ebay. The other parts too. It would be simple to swap out the cylinder but keep your rachet so the timing is not affected. A Norwalk shroud would not match the rollmark. Members with with chromed guns might be interested in your shroud or parts.