Register
Log In
Home
Dans Club
October 17, 2008
Offline
Ok, I picked up a Model 715 for the barrels, didn't really need the revolver well it gets here and the cylinder release is missing the spring and pin or screw that holds it in place. So the cylinder will just push open and when you open it the latch will just slide up off the crane.
Any one have an idea how hard the parts will be to get and how hard of a fix is this for a guy with lots of Dan's and not much of a gunsmith.
Thanks in advance.
Supporter
Moderators
Dans Club
February 22, 2009
Offline
Very easy- on a scale of 1-10, it's a 2;
Call DW Parts, 607.336.1174 ext 21, purchase a latch spring and latch spring retaining pin. Look at schematic, slide the latch up and out, place spring in, replace latch, screw in retaining pin. Viola!
Technically, the glass is always full; half liquid, half air....
Supporter
Range Officer
Moderators
DWF Supporters
Dans Club
December 4, 2011
Offline
Ditto what Ron said, easy fix.
Anything worth doing is worth doing well.
My father
If a man designed it, and a man built it, then a man can fix it.
My grandfather
Supporter
Range Officer
Dans Club
Range Officers
Members
July 2, 2011
Offline
SS = Super Simple.. or..... Stainless Steel 
To the paranoid people who check behind shower curtains for murderers:
if you find one...what's your plan?
Dans Club
December 5, 2008
Offline
Dan Fan,
PM me. I have the parts you need. Free shipping.
March 8, 2017
Offline
What size is the latch retaining screw on a 715? Is it a 2-56?
Dans Club
March 2, 2008
Offline
fredd3039 said
What size is the latch retaining screw on a 715? Is it a 2-56?
Perhaps you might visit New Members?
I went to a bookstore and asked the saleswoman "Were is the Self Help Section?" She said if she told me, it would defeat the purpose.
George Carlin
1 Guest(s)
