Register
Log In
December 18, 2011
Offline
have just got a hogue grip for my 357 sm and am having a ....time getting the screw to align to the frame. has anyone ever had this (minor) prob?
February 11, 2010
Offline
Try a couple drops of oil both ends of screw and see if that helps.
Â
-Blacktop
February 21, 2011
Offline
Which grip? They make several types. Wood, rubber?
Do you have the version with the small slot-head screw or the bigger hex head one?
Matthew Quigley on handguns:
âI said I never had much use for one. Never said
I didn't know how to use it.â
September 8, 2011
Offline
If its the rubber you just gotta really put some pressure on it for the threads to catch . And once you get the thread started ONLY TURN IT ABOUT 10 TURNS .... I found out the hard way if you over tighten it you crush the little plastic floor plate and the hammer wont lock back because the screw is in too far .. not to mention now since I over tightened it since I had to back the screw out so it wouldn't obstruct the hammer and the plastic plate is crushed I now have about 1/8 - 1/4 inch play in the grips -__-
" Democracy is two wolves and a lamb voting on what to have for lunch , Liberty is a well armed lamb contesting the vote " - Ben Franklin
1 Guest(s)
