Register
Log In
February 13, 2012
Offline
Hi,
I received a package this afternoon with the replacement springs. I went ahead and disassemblied my .357 using the steps outlined on this site. At least until it got to the point of removing the roll pin holding in the firing pin and spring. It sure seems to be mighty tight and I'm worried about messing up the finish around the hole. Can someone please confirm the size of punch I should be using?
Thanks,
Glen
Supporter
Range Officer
Range Officers
May 2, 2009
Offline
Some of them are stiff--just put some oil on it and let it sit. 1/16" punch is proper size.
You need thave it steady anytime you are using the punch--I suggest removing the cylinder, gives you a better frame to anchor down.
SHOOT
February 13, 2012
Offline
Thanks Shoot, that took care of it.Â
Glen
January 27, 2012
Offline
Is it on all Dan Wessons or just mine that the pins are inserted from the left hand side( as holding the gun) I found driving them out from the right was a piece of cake...but I did soak the revolver down in PB blaster for two days before attempting to disassemble it.
1 Guest(s)
