Register
Log In
April 27, 2014
Offline
I purchased an early 715 from the son of an old timer , when it arrived I found the cyl gap was so tight that a loaded cyl wouldn't turn, after buying a wrench and a new nut from EWK I reset the gap and set off for the indoor range.
It was immediately clear that all was not right, the shots were all printing way left, even after adjusting the rear sight as far right as it goes the shots were still 4" to the left, at 20yds.
The only other thing I changed was a higher (partridge) front sight so that I could use a sub 6 hold for ISSF competition, thinking I'd use the DW and sell my MR38 Manurhin as things are a little tight.
Could using a new barrel nut have done this?
Supporter
Moderators
Dans Club
February 22, 2009
Offline
Short answer; no.
In your post just over a year ago, you stated the rear sight was loose. I would replace the rear sight.
Technically, the glass is always full; half liquid, half air....
August 8, 2016
Offline
rwsem said
Short answer; no.In your post just over a year ago, you stated the rear sight was loose. I would replace the rear sight.
 Â
1 Guest(s)
