Log In
Dans Club
December 7, 2020
Offline
Bought a one-owner '76 15-2 with reloaded ammo that is likely 25-40yrs old.
These were included with the old NIB ammo.
Supporter
Dans Club
March 25, 2013
Offline
Wadcutters. For target shooting. Probably 38 Special. They make perfectly round, neat holes. Used against flesh they can be devastating.Â
DWF Supporters
July 12, 2020
Offline
.38 Special mid range. I shoot them in my S&W Model 52-2.
March 19, 2016
Offline
I use to have a bullet mold for wad cutter lead bullets. 135 gr bevel base. Use to load them up side down. They would put a 1/2â hole in a piece of plywood
Dans Club
December 7, 2020
Offline
Ole Dog said
Wadcutters. For target shooting. Probably 38 Special. They make perfectly round, neat holes. Used against flesh they can be devastating.ÂÂ Â
They are 38S.  Being flat, do they damage the barrel?
February 21, 2011
Offline
Nope they're lead which is much softer than steel.
Matthew Quigley on handguns:
âI said I never had much use for one. Never said
I didn't know how to use it.â
Supporter
Dans Club
March 25, 2013
Offline
Upside down like 10Magnuns loaded them they are essentially hollow points. Ouch!!!Â
Dans Club
January 17, 2015
Offline
Lots of our local target shooters load wadcutters like this for target shooting. Boosts case pressure, thus requiring minimal powder; or, as they prefer to say, "just enough powder to knock the [steel] target over".
August 8, 2016
Offline
Wadcutters of course! Surprised you hadnât seen those before. Nice clean holes in paper targets as others have said.Â
May 26, 2015
Offline
My local range used to carry copper plated wadcutters, I still have a small amount left! Very light shooting usually.
Dans Club
December 7, 2020
Offline
Andrew1220 said
Wadcutters of course! Surprised you hadnât seen those before. Nice clean holes in paper targets as others have said.ÂÂ Â
I have just never seen them completely sunken into the brass before.  I guess before, I assumed the a flat-nosed, semi-wadcutter was only kind?
1 Guest(s)
