Log In
April 10, 2011
Offline
Ok I have been doing some searching on the forum for topics about refinishing Dan Wessons. I haven't been able to find much a topic here and there with a few recomendations but very few pics. I personally am interested in a brushed hard chrome.  I am a little concerned about possible chipping/flaking where the shroud comes into contact with the frame.
Â
Has anyone had any experience with this? Or other finishing processes. I also like the idea of Robars NP3 plus but not sure about the look.Â
Â
Questions comments and most important pictures.
Â
thx
Raider
December 27, 2010
Offline
If hard chrome is done right it will not chip.Ihad 350 shafts industrial hard chromed and they cycle up and down through a packing box about 10 times a hour for over 5 years with no signs of wear but then it depends on who is doing the plating.
1 Guest(s)
