Log In
December 8, 2012
Offline
Got a set of hogue rubber grips for my 15-2 and the standard grip screw does not work has anyone else had this problem?ÂÂ
Dans Club
DWF Supporters
April 20, 2010
Offline
Why doesnt the screw work? Is it too long or too short?
  I did buy a new Hogue at one time, if I remember correctly the hole was a little small for the screw head to fit in. I carefully countersunk the hole slightly bigger with a drill. Or you could grind down the head of the screw til it fits in. Is that the issue you are having?
-Lonwolf
"The lion and the tiger may be more powerful, but the Wolf does not perform in the circus"
July 8, 2012
Offline
I bought a new set of Hogue grips a while back. I found that the screw from my DW target grips was too long, but the screw from my DW service grips, which is shorter, works well.
Huffy
Supporter
Moderators
Dans Club
February 22, 2009
Offline
It's common. Many folks over tighten the rubber grips and that interferes with the action. You can purchase a short screw at the hardware store or chase a nut onto it, then grind or cut away some threads.
Technically, the glass is always full; half liquid, half air....
Dans Club
March 2, 2008
Offline
lonwolf93 said
  I did buy a new Hogue at one time, if I remember correctly the hole was a little small for the screw head to fit in. I carefully countersunk the hole slightly bigger with a drill. Or you could grind down the head of the screw til it fits in. Is that the issue you are having?
-Lonwolf
I have had this same problem with Hogue wood grips as well
I went to a bookstore and asked the saleswoman "Were is the Self Help Section?" She said if she told me, it would defeat the purpose.
George Carlin
December 8, 2012
Offline
I finally took a .370 reamer and slowly reamed out the end of the grip until the grip screw went through far enough to engage the grip frame. Hate to have to modify a new grip to get it to work.
1 Guest(s)
