Register
Log In
DWF Supporters
April 14, 2018
Offline
I purchased a new rubber Hogue monogrip for my DW 44 and Iâm very disappointed. The hole for the grip screw wasnât even close to the center of the round hole for the tang. I tried drilling the hole straighter but the rubber doesnât drill cleanly with a twist drill and I eventually ruined it. Never was able to get the grip screw started.
I like the Hogue on my 15-2 and would like to use the same style on the 44 because it gives great support when shooting with the long heavy barrels. Any suggestions out there on what to do to get this done?
August 28, 2009
Offline
Buy another one, but this time don't destroy it if the screw isn't lined up. They're warranted and will replace it. Alternatively, I have a few new ones and can sell you one...I need to buy a couple small frame Hogues.
DWF Supporters
April 14, 2018
Offline
If you would look to see that the grip screw hole is centered in the tang hole I certainly would buy one of yours.Â
August 28, 2009
Offline
1 Guest(s)
