Register
Log In
April 30, 2011
Offline
Had a Bubba moment while removing a stuck barrel tube and bent the ejector rod. Â I removed the rod and straightened such that the weapon functions normally but still a slight bit of run out I can't seem to clean up. Â Two part question: from all I can tell this shouldn't be a "fitted" part so a replacement should be drop in - correct? Â Second, is the ejector rod common to both small and large (non-supermag) frame revolvers or do I need to chase a large frame part only??
Supporter
Dans Club
March 25, 2013
Offline
It is a drop in part. Actually, a screw in part. There are 3 sizes. Small frame, large frame and supermag. Corresponds to the longer cylinder lengths on the large and supermags. DW should have them. Don't call CZ.Â
February 16, 2016
Offline
Call Shawn in Spare Parts at the Dan Wesson manufacturing plant in Norwich on 607-336-1174 extension 21.
1 Guest(s)
